Summer Starts Here - Save up to 70%
Trailer Wiring Harness Installation - 2003 Chrysler PT Cruiser- Video
Today our 2003 Chrysler PT Cruiser we'll be installing the Curt T-Connector Wiring Kit, part number C55532. To begin with we'll need to remove both tail light assemblies by removing the torxhead screw that's at the lower section on the tail light assembly. Once you pull the tail light assembly out, because careful not to break the clips off as you're removing the tail light assembly. Then we will go ahead and unplug both plugs from the rear of the assembly. On this case we used a small screw driver to help release both of the locking tabs. Once we have the passenger side light assembly out and the wires disconnected we will go ahead and drop down the 4-flat as well as the yellow wire with the connectors down through the light assembly and under the rear bumper fascia. We'll plug the grey connector that has two wires into it with the green wire into the vehicle's harness, making sure that the locking tabs snap into place. We will also make the connection with the plug that has three wires, one of them has a brown and red wire in it as well. more
11/10/2014 10:45:27 AM
Trailer Wiring Harness Installation - 2004 Chrysler PT Cruiser- Video
Today on a 2004 Chrysler PT Cruiser, we're going to install product number 118462 from Tow Ready. First thing we need to do is go ahead and remove the tail lights. We're going to remove the wire harness from the tail light we're pushing on the sides of these little tabs right here. Sometimes its easier to push it with a screwdriver. We're going to start off by running a 4-pole wire and our T-connector half with a yellow wire down to the bottom of the tail light and out at the bottom of the bumper. Next, we'll go ahead and remove, attach our ground wire to the body which connects this to a sheet metal around the side here which we'll attach to that. more
1/11/2012 3:21:17 PM
Filter Videos
Filter Videos
